The build stack has also been completely redesigned. To further enclose the build chamber the S7 only has one magnetically latched door. This filters the exhaust air of every print and also improves build temperature stability. It now includes an integrated Air Manager. ![]() The UltiMaker S7 is built on the success of the UltiMaker S5 and its design decisions were heavily based on feedback from customers. G1 F9000 X150 Y2.0 Z1.0 wipe away from the filament line G1 F1500 X5.0 Y5.0 Z0.3 Move to start of purge line G1 F600 Z0.3 drop down to purge line height G1 F1500 E15 extrude some filament to make sure it's up to the nozzle Slicer Information - (Support for OctoPrint Slicer Estimator) Anyway, here is what's currently in my Startup gcode: How would I change the gcode to move it inward a few mm? Thanks. I would imagine if it did the same thing a few mm inboard nothing would go wrong. I think it is only an issue because it is doing the wipe right at the edge, and can affect the edge of the bed coating as a result. If it could be moved inboard from the border slightly again it would probably be fine. The behaviour itself probably isn't a problem, but rather the location of it has made it problematic. How would I return it to the old behaviour? I'm assuming this is some change in the pre-print gcode but I do not know what to change or what to change it to. It seems as though the edge of the coating has been lifted up or removed now, and that area has slowly been getting larger. This seemed like an improvement at the time, but now that location of the bed has begun getting damaged. A handful of versions back the profile for the Anycubic Mega S changed the start-of-print behaviour to wipe the nozzle at the edge of the bed rather than printing a line slightly inboard of the border.
0 Comments
Leave a Reply. |